The following RMC150 modules have two Control Outputs, one for each axis: Analog (G), Analog (H), MDT (M), Quadrature (Q), SSI (S), Resolver (R). The Control Output is labeled Drive, except on the Quadrature module, where it is pin 12.
Use shielded twisted pairs for all connections to inputs and outputs. See Wiring Guidelines for general wiring information.
On modules with wire clamp screws, the screws must be tightened to max 4.5 lb-in (0.51 Nm).
See Also
Analog (G) Module (RMC150) | Analog (H) Module (RMC150) | MDT (M) Module (RMC150) | Quadrature (Q) Module (RMC150) | SSI (S) Module (RMC150)
Copyright © 2024 Delta Computer Systems, Inc. dba Delta Motion