Command: Restore Controller Image (121)

Firmware Limitations:

See the Commands Overview topic for basic command information and how to issue commands from PLCs, HMIs, etc.

Command Parameters

None.

Description

This command restores the controller image from the RMC200 SD card to the controller and then restarts the controller 500 msec after the image was restored. Restoring the image may take up to several seconds. The controller image must exist as a file on the SD card named ControllerImage.bin in the root folder. The Event Log will provide an error message if the restore failed.

The Controller Image Command State register can be used to monitor the status of the restore operation.