All of the following was true:
An Auto-Repeat curve was downloaded to an axis with an absolute transducer type such as MDT, SSI, or Analog, which cannot be offset.
The curve's first and last points were at different positions.
The curve was followed beyond its last point, thus triggering an Auto-Repeat.
If any of the above was not true, then an error would not have been generated. That is, Auto-Repeat curves are allowed on non-offsettable axes, provided their endpoints match. However, because this situation did occur, the curve still Auto-Repeated, but did not offset the position back to the first position in the curve.
Copyright (c) 1997-2015 by Delta Computer Systems, Inc.