Adding an Expansion Module to a Controller

To add an expansion module to an RMC75 controller:

1. Disconnect power to the RMC75.

2. Remove the 4 screws on the far right side of the top and bottom surfaces of the controller.

3. Plug the expansion module into the right side of the controller.

4. Install the 4 screws into the same holes they were removed from in step 2.

5. Apply power to the RMC75.

6. Open RMCTools and open your project. If you do not have a previous project, start a new project and do not continue this procedure.

7. Go online with the controller. If the Controller Hardware/Firmware Differences dialog opens, click Go Online. Save the project. On the controller menu, click Update Flash to save the RMC75 settings to Flash memory.

If you are not able to go online with the controller, you can configure your project in RMCTools to include the expansion module as follows:

1. • Right-click the controller and click Properties.

   • Click Add Module, select the module you just added, and click OK.

   • Click OK, download the settings to the controller, and go online with the controller.

See Also

Expansion Modules Overview

Send comments on this topic.

Copyright © 2024 Delta Computer Systems, Inc. dba Delta Motion